LED strobe warning light high visibility, no maintenance when in use. The external rotating lampshade, while maintaining high brightness, does not lose the classic visual design, and the built-in unique filter system can effectively spread the LED light. It uses about half as much electricity as an incandescent bulb. (100V/200V ac), protection class is IP54. Multi-layer LED arc surround design, uniform lighting, high brightness, no dead point, no bad contact. Can be continuous rapid tristrobe flash form, produce strong visual impact, warning effect is better. The colors are red, yellow, green and blue. Scientific parabolic mirrors spread light farther. Rubber gasket is used to prevent rain and dust.
What should you do when using a strobe warning light? Let's take a look:
Lead out the two power cables for the strobe warning light.
When using AC power supply, do not consider the positive and negative terminals, regardless of color.
When using DC power, connect the black power cable to the negative terminal.
The structure of the strobe warning light is an indoor general structure, and can be installed at will if used indoors.
When using stroboscopic warning lights outdoors, try to avoid wet places and vertical installation.
Try to choose less moisture and dust, vibration and shock installation of this product.
When the voltage difference is very high or very low than the rated voltage, the service life of the product will be shortened or the operation of the product will be abnormal. The voltage used must be controlled to fluctuate 5% above or below the rated voltage.
The lamp shade or base surface contact with corrosive chemicals will damage the product resulting in deformation or fading phenomenon, users should pay special attention to.
Avoid the strong impact of the product, which will cause a series of problems such as short circuit fault and so on.
The wires exposed to the product cannot be stretched compulsively, which is one of the causes of product failure.